臭氧耦合陶瓷膜过滤对膜性能及出水消毒副产物的影响

利用臭氧（O₃）-陶瓷膜过滤（CMF）处理常规工艺出水,研究了不同O₃-CMF耦合方式对膜性能和消毒副产物（DBPs）的影响.结果表明,与单独CMF相比,异位O₃-CMF和原位O₃-CMF均可以有效缓解膜污染,原位O₃-CMF控制效果最佳.异位O₃-CMF对进水（常规工艺出水） DOC去除率（26.25%）略高于原位O₃-CMF（22.31%）,但是其SUVA去除率（83.91%）明显低于原位O₃-CMF（93.10%）.羟基自由基（·OH）生成特征表明原位O₃-CMF可促进O₃产生更多的·OH.在O₃、·OH氧化和陶瓷膜截留协同作用下,异位O₃-CMF和原位O₃-CMF出水中总荧光响应强度和相对分子质量大于0.3×10³,有机物含量降低,进而使得出水中含碳消毒副产物（C-DBPs）生成量分别降低了21.86%和32.35%,含氮消毒副产物（N-DBPs）生成量分别降低了16.16%和19.13%.但O₃和·OH氧化后生成的小分子有机物因难以被CM截留导致其在出水中含量增加,进而增加了卤代酮（HKs）、水合氯醛（CH）和三卤硝基甲烷（THNMs）的产生.本研究对于不同O₃-CMF方式下O₃与CM的协同机制的探讨,改善膜性能和提升DBPs前体物的去除具有一定指导意义.     

Body fluid analog chlorination: Application to the determination of disinfection byproduct formation kinetics in swimming pool water

Disinfection by-products(DBPs) are formed in swimming pools by the reactions of bather inputs with the disinfectant.Although a wide range of molecules has been identified within DBPs,only few kinetic rates have been reported.This study investigates the kinetics of chlorine consumption,chloroform formation and dichloroacetonitrile formation caused by human releases.Since the flux and main components of human inputs have been determined and formalized through Body Fluid Analogs(BFAs),it is possible to model the DBPs formation kinetics by studying a limited number of precursor molecules.For each parameter the individual contributions of BFA components have been quantified and kinetic rates have been determined,based on reaction mechanisms proposed in the literature.With a molar consumption of 4 mol Cl_2/mol,urea is confirmed as the major chlorine consumer in the BFA because of its high concentration in human releases.The higher reactivity of ammonia is however highlighted.Citric acid is responsible for most of the chloroform produced during BFA chlorination.Chloroform formation is relatively slow with a limiting rate constant determined at 5.50 × 10~(-3) L/mol/sec.L-histidine is the only precursor for dichloroacetonitrile in the BFA.This DBP is rapidly formed and its degradation by hydrolysis and by reaction with hypochlorite shortens its lifetime in the basin.Reaction rates of dichloroacetonitrile formation by L-histidine chlorination have been established based on the latest chlorination mechanisms proposed.Moreover,this study shows that the reactivity toward chlorine differs whether L-histidine is isolated or mixed with BFA components.     

组合工艺控制有机物和消毒副产物的研究

利用MBBR预处理、常规处理及臭氧活性炭深度处理组合工艺I型和预臭氧氧化、常规处理及生物活性炭深度处理组合工艺II型,对郑州段黄河水进行有机物和消毒副产物去除效果的研究,结果表明:在臭氧投加量均为1mg/L的条件下,两种组合工艺对高锰酸盐指数、UV254和三卤甲烷生成势TFMP都有良好的去除效果,能提供安全的优质饮用水。     

臭氧在"臭氧-生物活性炭"饮用水处理工艺中的作用研究

本文通过分析饮用水深度处理中试工艺各处理单元出水水质指标的变化研究臭氧在臭氧生物活性炭工艺中的作用。试验结果表明：在中试工艺中，臭氧具有很好的氧化、杀藻和消毒的作用；并且两级臭氧氧化分别对常规处理单元和颗粒活性炭去除污染物具有一定的促进作用。     

Control of aliphatic halogenated DBP precursors with multiple drinking water treatment processes: Formation potential and integrated toxicity

The comprehensive control efficiency for the formation potentials(FPs) of a range of regulated and unregulated halogenated disinfection by-products(DBPs)(including carbonaceous DBPs(C-DBPs), nitrogenous DBPs(N-DBPs), and iodinated DBPs(I-DBPs)) with the multiple drinking water treatment processes, including pre-ozonation, conventional treatment(coagulation–sedimentation, pre-sand filtration), ozone-biological activated carbon(O_3-BAC) advanced treatment, and post-sand filtration, was investigated. The potential toxic risks of DBPs by combing their FPs and toxicity values were also evaluated.The results showed that the multiple drinking water treatment processes had superior performance in removing organic/inorganic precursors and reducing the formation of a range of halogenated DBPs. Therein, ozonation significantly removed bromide and iodide,and thus reduced the formation of brominated and iodinated DBPs. The removal of organic carbon and nitrogen precursors by the conventional treatment processes was substantially improved by O_3-BAC advanced treatment, and thus prevented the formation of chlorinated C-DBPs and N-DBPs. However, BAC filtration leads to the increased formation of brominated C-DBPs and N-DBPs due to the increase of bromide/DOC and bromide/DON.After the whole multiple treatment processes, the rank order for integrated toxic risk values caused by these halogenated DBPs was haloacetonitriles(HANs)》haloacetamides(HAMs) haloacetic acids(HAAs) trihalomethanes(THMs) halonitromethanes(HNMs) 》I-DBPs(I-HAMs and I-THMs). I-DBPs failed to cause high integrated toxic risk because of their very low FPs. The significant higher integrated toxic risk value caused by HANs than other halogenated DBPs cannot be ignored.     

Concentrations of disinfection by-products in swimming pool following modifications of the water treatment process: An exploratory study

The formation and concentration of disinfection by-products (DBPs) in pool water and the ambient air vary according to the type of water treatment process used. This exploratory study was aimed at investigating the short-term impact of modifications of the water treatment process on traditional DBP levels (e.g., trihalomethanes (THMs), chloramines) and emerging DBPs (e.g., Halonitromethanes, Haloketones, NDMA) in swimming pool water and/or air. A sampling program was carried to understand the impact of the following changes made successively to the standard water treatment process: activation of ultraviolet (UV) photoreactor, halt of air stripping with continuation of air extraction from the buffer tank, halt of air stripping and suppression of air extraction from the buffer tank, suppression of the polyaluminium silicate sulfate (PASS) coagulant. UV caused a high increase of Halonitromethanes (8.4 fold), Haloketones (2.1 fold), and THMs in the water (1.7 fold) and, of THMs in the air (1.6 fold) and contributed to reducing the level of chloramines in the air (1.6 fold) and NDMA in the water (2.1 fold). The results highlight the positive impact of air stripping in reducing volatile contaminants. The PASS did not change the presence of DBPs, except for the THMs, which decrease slightly with the use of this coagulant. This study shows that modifications affecting the water treatment process can rapidly produce important and variable impacts on DBP levels in water and air and suggests that implementation of any water treatment process to reduce DBP levels should take into account the specific context of each swimming pool.     

Formation of THMs and HANs during bromination of Microcystis aeruginosa

Bromine-contained disinfectants and biocides are widely used in swimming pools, recreational waters and cooling towers. The objective of this study was to evaluate the formation of thrihalomethanes (THMs) and haloacetonitriles (HANs) and their cytotoxicity in algae solutions during free bromine disinfection. Disinfection by-products formation potential experiments were conducted using model solutions containing 7 mg/L (as total organic carbon) Microcystis aeruginosa cells. Effects of free bromine dosage, pH and ammonia were investigated. The results showed that brominated disinfection by-products were the major products when free bromine was applied. The total THMs formed during bromination was much as that formed during chlorination, whereas HANs were elevated by using bromination instead of chlorination. Dibromoacetonitrice (C2H2NBr2 ) and bromoform (CHBr3 ) were the only detected species during free bromine disinfection. The production of C2H2NBr2 and CHBr 3 increased with disinfectant dosage but decreased with dosing ammonia. CHBr3 increased with the pH changing from 5 to 9. However, C2H2NBr2 achieved the highest production at neutral pH, which was due to a joint effect of variation in hydrolysis rate and free bromine reactivity. The hydrolysis of C2H2NBr2 was base-catalytic and nearly unaffected by disinfectant. Finally, estimation of cytotoxicity of the disinfected algae solutions showed that HANs formation was responsible for the majority of toxicity. Considering its highest toxicity among the measured disinfection by-products, the elevated C2H2NBr2 should be considered when using bromine-related algaecide.     

次氯酸钠氧化消除水中BPA的影响因素和动力学

采用常用消毒剂次氯酸钠对内分泌干扰物双酚A（BPA）的氧化消除及动力学规律进行研究,考察了加氯量、BPA初始浓度、pH值、Br^-浓度和温度各因素对降解效果的影响.结果表明,次氯酸钠对BPA的氧化降解过程符合拟一级反应动力学;pH值对该降解反应影响较大,当pH为8～9时,BPA与 HOCl的反应速率达到最大为0 .544 3　min^-1;溶液中存在Br^-会加快BPA的降解,并且其整体反应不符合拟一级动力学规律,随着Br^-浓度的增加,BPA降解得越快;温度对该降解反应的影响较大并且符合Van't Hoff规则,提高反应温度,有利于氯对BPA的降解.     

内分泌干扰物4-叔丁基苯酚在水中的氯化动力学研究

对典型内分泌干扰物4-叔丁基苯酚（4-TBP）在水中的氯化反应动力学进行了研究.结果发现,在不同HOCl初始浓度和pH条件下,4-TBP能够迅速被氯氧化,4-TBP的氯化反应符合二级反应动力学.表观速率常数k_app与pH值有关,在pH为5和9左右时,k_app分别达到最小值和最大值;对氯化反应中的每一个基元反应的反应速率常数进行了计算, HOCl与4-TBP的酸催化反应及ClO^-与4-TBP反应的速率常数分别为4.99×10⁶　L²·（mol²·min）^-1和1.96×10⁴　L·(mol·min)^-1,而HOCl与4-TBP的反应及HOCl与4-TBP^-的反应较慢,4-TBP^-与ClO^-不发生反应.水处理中氯消毒工艺对4-TBP的降解有一定的影响,在氯投加量为3 mg/L时,4-TBP的半衰期为12.1　min.     

高锰酸盐复合药剂预氧化对摇蚊幼虫DBPsFP的去除控制研究

以花翅摇蚊幼虫为试验对象,研究高锰酸盐复合药剂预氧化对摇蚊幼虫代谢产物在氯化消毒过程中消毒副产物前体物的去除控制.研究表明:在p H由5升高到9时,三氯乙酸(TCAA)与二氯乙酸(DCAA)的浓度呈逐渐减少趋势;p H由5升高到7时,三氯甲烷(TCM)和三氯乙腈(TCAN)的浓度减幅最大,1,1-二氯丙酮(1,1-DCP)和1,1,1-三氯丙酮(1,1,1-TCP)则在p H为8时浓度达到最低值;随着药剂投加量的增加,TCM呈现出持续稳定增长趋势,DCAA呈总体下降趋势,而TCAN、1,1-DCP、1,1,1-TCP和TCAA则先增加后减少,高锰酸盐的投加量为3mg·L-1时,消毒副产物去除效果显著;延长预反应时间,TCM呈总体上升趋势,1,1-DCP、DCAA、TCAA呈下降趋势,TCAN、1,1,1-TCP呈先增加后减少的趋势,综合考虑最佳预氧化时间为30 min;投加混凝剂能够有效控制消毒副产物前体物的生成,随着混凝剂的不断增加,TCM、1,1,1-TCP呈先增加后减少的趋势,TCAN、1,1-DCP、DCAA、TCAA浓度则逐渐降低,在投量为40 mg·L-1时,达到最低值.